Goods, should be prepared
The following are required in order to assemble the game board and parts which were
printed.
- The thing used as the base of a game board.
The following things will be good.
- The styrene board which has adhesive on one side.
Processing is easy.
- Plywood
Processing is slightly troublesome. It makes by the technique of decoupage.
- Corrugated cardboard
Please choose the good-quality thing.
- Toothpick, Paper clip, etc.
Thin wooden stick and wire
- Others
Adhesives, a lacquer spray, etc. are required.
Assemble the game board
The game board of LDR(17 x 11) size is created as an example using a styrene board
with adhesives.
1. Processing of a joint
When creating LDR(17 x 11) size from what was printed on LTR(8.5 x 11) paper, the
portion which becomes a joint is cut. (It is unnecessary when it prints on LDR paper.)
1.
The margin portion is cut off.
The margin portion of the printed game board is cut off roughly.
The joint part of right and left, please cut a mark of right and left either in
the middle of a pattern.
2.
Please unite the mark in the upper and lower sides of a joint, and tack weld with
a tape.
3.
Ruler is applied to the central line of a mark and cut it by a cutter.
2. Stick on the base
1.
Please cut it leaving some margins. And cut the base to the size that is about the
same as it.
2.
As there is no gap, it sticks from an edge.
3.
Be careful of a joint and put it the another sheet.
3. Make a hole
Make a hole in the center of a round mark with the pointed thing like a drill and
a eyeleteer.
4. Cut a margin
Cut a margin part together with a base.
5. Finish
You should paint with clear lacquer to protect the surface of the game board.
When you use a styrene board, please use water-based paint.