- The first down marker
It places on a game board as a mark of first down.
- Ball position
It places on a game board as a mark of the present ball position.
- Down indicator
It is used in order to show what down it is now.
The first down marker
Because the first down marker and ball position marker are two kinds each, please
use either.
Assembling of first down marker A
1.
Cutting
Please cut a parts neatly.
2.
Processing of wire
Please bend a wire or a lengthened paper clip to the form of the marker.
In order to insert in the hole of a game board, please bend a tip to the down side
about 4mm(0.16in).
A yellow portion is cut off according to the length of wire.
3.
Bonding
Because it is paper and the metal adhesion, please use synthetic rubber adhesive
or epoxy based adhesive.
When you use synthetic rubber adhesive, you apply a thin coat of it to adhesion
aspect all and you thrust it after semidrying and adhere.
4.
Finish
It is completion when it can adhere well.
Assembling of first down marker B
1.
Cutting
Please cut a parts neatly. A sole plate is cut somewhat more greatly than a line.
2.
Make a pin
The toothpick cut short, wire or a paper clip are used.
3.
Bonding
In the case of a toothpick, please use bond for woodwork, and in the case of wire,
please use synthetic rubber adhesive or epoxy based adhesive.
4.
Sole plate
Please glue sole plate together.
5.
Finish
When you adhere well and cut sole plate, it is completion.
Ball position
Assembling of ball position A
1.
Cutting
Please cut a parts neatly. A sole plate is cut somewhat more greatly than a line.
2.
Make a pin
Wire and a paper clip are used. Bend so that the point comes out from a sole plate
downward about 4mm(0.16in).
3.
Bonding
Please adhere with synthetic rubber adhesive or epoxy based adhesive.
4.
Sole plate
A sole plate is pasted up.
5.
Finish
When you adhere well and cut sole plate, it is completion.
Assembling of ball position B
1.
Cutting
Please cut a parts neatly. A sole plate is cut somewhat more greatly than a line.
2.
Make a pin
The toothpick cut short, wire or a paper clip are used.
3.
Bonding
In the case of a toothpick, please use bond for woodwork, and in the case of wire,
please use synthetic rubber adhesive or epoxy based adhesive.
4.
Finish
When you adhere well and cut sole plate, it is completion.
Down indicator
1.
Cutting
Please cut a parts neatly, and bend it.
2.
Bonding
Please apply adhesives to a tab for sticking, and paste it.